Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
When the average is displayed, press the "MEM", and the most
recent result will be displayed. Followed by blood pressure and
pulse rate, which are displayed separately. The irregular heartbeat
symbol will flash. Press the "MEM" button again to review the
following result. Repeatedly pressing the "MEM" button will display
the respective measured results above.
When the stored results are displayed, the monitor will switch off
automatically after 1 minute of non-operation.
Alternatively, you can press the "START" button to turn off the
monitor manually.
Remove the memory readings
When any result is displayed, all results will be erased by holding
down the "MEM" button for three seconds. Press the "MEM" or
"START" button and the monitor will switch off.
Technical alarm description
The monitor will immediately display "Hi" or "Lo" as a technical
alarm on the LCD if the blood pressure (systolic or diastolic) is
outside the target range specified in the specifications. In this case,
you should consult a physician or check if your operation violated
the instructions.
The technical alarm condition (outside the nominal range) is factory
preset and cannot be adjusted or deactivated. This alarm condition
is assigned as low priority according to IEC 60601-1-8.
The technical alarm is not locked and does not need to be reset.
The signal that is displayed on the LCD screen will disappear auto-
matically after about 8 seconds.
Rapid deflation during reading.
If you feel unwell during the reading or you wish to stop the device
for any reason, you can press the on/off button for the device to
quickly release the air from the cuff and the device will return to
standby mode.
To ensure that the values are comparable, always take a pressure
reading at the same time.
If you want to perform more than one reading for the same person,
wait 5 minutes between each reading.
23
Publicité
