Care & Maintenance - Pro-Point 8663833 Manuel D'utilisateur

8663833
8. Repeat on other side of table to install the second beam.
9. Install the two long beams between the legs on the long
sides of the table.
10. Place a long beam (#5) on the inside of the support legs.
The beam's flat top will face the bottom of the table. Align
the bolt holes and make sure the flat top is either over or
under short beams on each end.
11. Align the bolt holes and pass a bolt (#9) from outside
through to the inside. Place a flat washer (#13), then a
spring washer (#7) on the bolt. Screw a nut onto the bolt
and hand-tighten. Repeat for other end of beam.
12. Repeat with the support legs on other side of the table.
13. Insert an anchor bolt (#12) through the end of each leg and
secure with a nut (#8).
14. Tighten all nuts with a wrench, then flip the table upright
for use.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace
damaged or worn components. Only use identical
replacement parts when servicing.
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does
not function properly or parts are missing. If unable to do so,
have a qualified technician service the tool.
6
24 X 36 IN. WELDING TABLE
For technical questions call 1-800-665-8685
V1.1