Troubleshooting - Imer Group MASTER 6010 DXL15 YN DE Manuel D'utilisation

12. TROUBLESHOOTING

When generator engine fails to start after several attempts, or if no electricity is available at the
output socket, check the following chart. If your generator still fails to start or to generate electricity,
contact your nearest IMER dealer shop for further information or corrective procedures.
12.1. WHEN ENGINE FAILS TO START:
Check if choke lever is in its proper position.
Check if fuel cock is open.
Check to make sure generator is not connected
to an appliance.
Check the charge level of the battery.
Check the proper connection of the solenoid valve
power cables and of the oil sensor.
12.2.
WHEN NO ELECTRICITY IS GENERATED AT RECEPTACLE
Check to make sure no-fuse breaker is in
the ''l'' (ON) position.
Check AC terminals for loose connection. Secure connection if necessary.
Check to see if engine starting was
attempted with appliances already
connected to generator.
Set the choke lever to ''CLOSE'' position.
Set the choke lever to ''CLOSE'' position.
If connected, turn off the power switch on the
connected appliance and unplug.
Must be over12V. Charge the battery.
Connect cables again, if necessary.
After making sure that the total wattage of the electrical
appliance is within permissible limits and there are no
defects in the appliance, turn the no-fuse breaker to the
''l'' (ON) position. If breakers continue to actuate, consult
your nearest servicing dealer.
Turn off switch on the appliance, and disconnect cable
from receptacle. Reconnect after generator has been
started properly.
:
17
EN
FR
ES
IT
RO