Adler europe AD 7934 Mode D'emploi page 4

device (RCD) in the power circuit, with residual current rating not more than 30 mA.
Contact professional electrician in this matter.
15. Do not use near water, or in damp rooms.
16. The device is intended for indoor use only. The device is not suitable for use in barns,
stables and similar outbuildings.
17. Do not spray the device with any chemicals.
18. Do not insert any objects into the lamp.
19. Do not cover the device - it can cause a fire.
20. The device should be cleaned regularly with dead insects.
21. Do not touch the high-voltage grid with your hands / metal or fluorescent lamps during
operation.
HIGH VOLTAGE 2200-2500V. Never touch the high tension grid when the
appliance is working, and should be kept away and out if reach from children.
USE
Make sure that the electrical outlet you are going to use is grounded and has the correct voltage 220-240V ~ 50 / 60Hz. The device can
operate continuously for 24 hours, 365 days a year. The device is not waterproof, do not expose to rain.
Set it on a countertop or hang the device by the attached chain in the desired place. A height of 1.5-2.0 meters is recommended as
optimal for flies, moths and other insects, and 1.0 meter for mosquitoes. Setting in a darker place away from windows and doors has a
positive effect on the effectiveness of the device, because the sun's rays weaken the radiation strength of the UV fluorescent lamps. Turn
the device on using the switch (5). The light will attract insects.
DESCRIPTION OF THE DEVICE: AD7934 Mosquitoes killer lamp
1. Housing
2. Protective grill
3. High voltage grid
4. Slide-out container for dead insects
5. On / off switch
6. Fluorescent lamps - UV 8W T5 BL
CLEANING AND MAINTENANCE
1. Before cleaning or maintenance, unplug the device and allow it to cool down.
2. Do not use chemical cleaning agents for cleaning. The device is not waterproof, do not wet clean the device. Clean the high voltage
grid (3) with a brush to get rid of the remains of insect bodies.
3. Regularly clean the insect container (4). The container (4) slides out like a drawer.
4. Replacing the fluorescent lamp:
Loosen the 4 screws on the side of the housing that does not have a switch (5). Then unscrew the 2 screws connecting the front and
rear protective grilles. Slide out the rear protective grille to get into the fluorescent lamps. Remove the fluorescent lamp by turning it
around its axis by approximately 90 ° until the latches release. Insert a new fluorescent lamp. To assemble, repeat the steps in reverse
order.
5. Make sure the device is dry before switching it on again.
Power supply: 220-240V ~ 50 / 60Hz
Power: 23.7W
IPX 0
Type of light source: UV 8W T5 BL fluorescent lamp - 2 pieces
High voltage grid voltage 2200-2500V
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
4