Ethan Allen 09-6139 Instructions D'assemblage

Hadlee Cement Table Lamp Assembly Instructions
IMPORTANT SAFETY INSTRUCTIONS
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, AND PERSONAL INJURY: This lighting fixture is for
indoor use only. This lamp is equipped with a polarized plug. One plug blade is wider than the other. DO
NOT MODIFY the plug or power cord in any way. DO NOT EXCEED the recommended bulb wattage. Use
only the type of bulb specified. Keep flammable materials away from bulb. DO NOT OPEN the product or
alter the wiring in any manner. Extension cord: Follow precautions provided with power cord.
Use care when unpacking. Locate ALL PARTS INCLUDED before disposing of packaging materials.
ASSEMBLY, CARE, AND TROUBLESHOOTING
No tools are required for assembly. Light bulb is not included.
Parts Included (refer to figure):
A. Harp (styles may vary)
B. Saddle
C. Shade (may be packed in separate carton)
D. Finial
E. Socket (attached, no assembly required)
F. Plug Cap
Assembly Procedure (refer to figure):
1. Insert Harp (A) into Saddle ( B).
2. Install Shade (C) onto Harp (A).
3. Screw Finial (D) onto Harp (A).
4. Install lightbulb into Socket Saddle (E).
5. Remove Plug Cap (F) from plug.
Care and Cleaning:
1. Clean with feather duster only.
2. AVOID cleaners, scouring pads, etc.
3. Before changing bulb, unplug lamp and
allow bulb to cool.
TROUBLESHOOTING:
Problem:
Bulb does not light
After troubleshooting, if the lighting fixture still does not work, contact your local Ethan Allen Design Center.
Page 1 of 1
09-6139
Possible Cause:
Bulb is burnt out or damaged
Power to lamp is off
Lamp is not plugged in
SAVE THESE INSTRUCTIONS
6/1/2018
What to Do:
Replace bulb
Confirm power is on
Confirm lamp is plugged in
©2018 Ethan Allen Global, Inc.