Wetelux Power Safe Light Mode D'emploi page 9

Inserting/Replacing the Batteries
The lamp is powered by three batteries of the type LR03
(AAA). The battery compartment is integrated into the
bottom of the lamp. Replace the batteries when the light
gets weaker.
1. Turn the base plate slightly counter clockwise and take
it off the lamp.
2. Insert three new batteries of the type LR03 into the
battery compartment. Pay attention to the proper polari-
ty of the batteries. The polarity is printed inside the
battery compartment. Reattach the base plate and lock
it in place with the bayonet latch.
Operation
You can set the switch on the back side of the lamp to the
positions ON, OFF and AUTO.
In the ON Position the lamp is turned on continuously, in
the OFF Position the lamp is turned off.
In the AUTO Position the lamp turns on in darkness
(<8 lux) as soon as the motion sensor is triggered and
remains on for approximately 30 seconds after the last
motion has been detected.
With the magnet at the bottom you can stick the lamp to
any magnetic surface.
Operation
IX