Nokia DC-1 Mode D'emploi page 4

Charge a device battery
You can use the power pack to charge
a battery in two compatible Nokia
devices at the same time.
To charge a device battery when no
charger is connected to the power
pack, do the following:
1. Connect your Nokia device to
either charger plug.
• To connect the device to the
charger plug provided with a
rewindable cable, lift the edge
of the rubber cover, uncoil the
cable, and insert the plug into
the charger connector on your
device.
• To connect the device to the
"DC OUT" plug, insert one end of
the supplied connectivity cable
to the plug and the other end to
the charger connector on your
device.
All manuals and user guides at all-guides.com
2. Press and hold the power key for
about 2 seconds to switch on the
power pack. The green indicator
lights are shown if the power pack
has charge.
The green indicator lights roll while
charging. (When you charge a low-
power device such as a Bluetooth
headset, the green lights may be
continuously shown at the final
stage of charging.) The less lights
are shown, the less charge is left in
the power pack. If the amber
indicator light is shown, the power
pack is discharged and must be
charged again for use.
3. Check the charge level from the
connected device.
4. To end the charging and switch off
the power pack, press and hold the
power key (for about 5 seconds)
ENGLISH