Power Failure; Temperature Control; Moving Your Appliance - Domo DO913DV Mode D'emploi

Masquer les pouces Voir aussi pour DO913DV:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 21
www.domo-elektro.be
BEFORE PLACING FOOD IN THE FREEZER
Remove all packaging.
Allow the appliance to run empty for 2 – 3 hours so the compartment can cool to
the appropriate temperature.
Clean the inside of the appliance with warm water and a little liquid detergent to
remove manufacturing and transportation dust.

POWER FAILURE

If there is a power failure, do not open the door. Frozen food should not be affected if
the power failure lasts for less than 15 hours.
Do not refreeze frozen foods that have thawed completely. The food may be
dangerous to eat.

TEMPERATURE CONTROL

The freezer is controlled with a temperature control knob located inside the appliance.
Adjust the control knob as desired to suit your individual
preference.
is warmest setting
4
is coldest setting
The running time and temperature are affected by where
the freezer is located, how often the door is opened and the temperature of the
room the freezer is located in.
When you use the appliance for the first time or after defrosting, adjust the control
knob to the coldest setting for at least 2 hours before introducing food to be
stored, and then readjust to the middle setting.

MOVING YOUR APPLIANCE

If the appliance is turned off for any reason, wait for 10 minutes before turning it back
on. This will allow the refrigeration system pressures to equalise before restarting.
Turn off the appliance and unplug it from the mains socket. Remove all food.
Also remove all mobile parts (drawers, etc.) or fix them into the freezer to avoid
any shock.
Relocate and install. If the appliance has been left on its side for any length of
time, leave it standing upright for at least 10 minutes before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an
environmentally friendly and natural gas, it is explosive. Therefore you should
be careful during shipment and installation to prevent your appliance's cooler
elements from being damaged. In the event of a leak caused by damage to the
cooler elements, move your freezer from open flame or heat sources and ventilate
the room where the appliance is located for a few minutes.
45
DO913DV

Publicité

Table des Matières
loading

Table des Matières