Publicité
Les langues disponibles
Les langues disponibles
SFM4SQ Installation:
1. Install Aculux housing per the instruction sheet shipped with
the recessed housing. Install ceiling with a precise cutout
measuring exactly 5.300" x 5.300" square (The bottom surface
of flangeless adapter can be used as a template).
2. Fasten flangeless adapter to housing via four screws as shown
in figure 3. (Rotation of adapter is not critical.) Level the adapter
using these screws until bottom surface of adapter is flush with
the ceiling.
3. Adjust vertical height of adjustment mechanism as outlined in
this instruction sheet.
4. Rotate and aim a fixture as desired.
5. If ceiling thickness is 1-1/4" or greater, adjust height of trim
springs as described in this instruction sheet.
6. Install trim into housing as follows:
a. Grab the end of one spring, and rotate up (away from the
finished face of the trim).
b. Engage the spring over the upper edge of the square
housing opening.
c. While holding trim in position, rotate second spring up and
insert into housing opening.
d. Push trim up until both springs engage.
Caution: The springs on the square trims snap closed upon removal
from the housing. Remove slowly and observe the location of the
springs. Keep fingers and hands clear of these springs to prevent
injury when removing.
Product Services Phone (888) 387-2212
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/aculux
©2018 Acuity Brands Lighting, Inc.
INSTALLATION INSTRUCTIONS
Figure 3
Rev 06/18
P5518
RECESSED
HOUSING
CEILING
FLANGELESS
ADAPTER
SCREWS (3X)
2 of 2
Publicité
