Britax Blink Instructions

Kit contents:
• Hinge cover - left
• Hinge cover - right
• Warning labels (qty 2)
WARNING!
Risk of finger amputation and laceration in
hinge. Do not use stroller without hinge covers
installed.
Hinge Cover Installation
1. Attach one warning label to each metal tube above
hinge joint on each side of the stroller frame.
2. Pull the lower canopy clamp from the metal tube.
(Fig. 2)
3. Slide the loop end of the elastic strap around one of
the clamp prongs (Fig. 3). Press the canopy clamp
back onto the metal tube.
4. Wrap left hinge cover around hinge joint on left side
of stroller with hook & loop strap on bottom. (Fig. 4)
5. Zip the hinge cover (5a), then close the hook & loop
strap over the zipper to secure (5b). Rotate the hinge
cover so the Britax logo faces out.
6. Repeat steps 1 – 5 to install left hinge cover.
Note: The hinge covers are left and right handed.
Ensure that the hook & loop strap is always fastened
toward the inside of the stroller and that the Britax logo
faces out.
Pag e 1 of 4
R1 :01. 10
P3 95800
Installation du couvercle de la charnière
1
Clamp
Prong
3
5a
6
Br ita x Chil d S a fe ty, Inc. , 13501 Sou th Ridg e D riv e, Ch ar lotte, NC 28273, U. S. A
Blink™ Stroller
Hinge Cover Installation
Pousette Blink™
Instructions
2
Hook &
Loop Strap
4
5b
Cons u mer S erv ices : 888. 427.4829
© 2010 Br ita x Chil d S a fe ty, In c. A ll r ights r es erv ed.
Clamp
Prong
www. Br itax .com