NexxTech 8003560 Manuel D'instructions

LED Alarm Clock
INSTRUCTION MANUAL
POWER SUPPLY
Your clock is designed to operate on alternating 120 volts
60 Hz power supply. The clock will start running when the
plug is connected to a power outlet.
P.M. INDICATOR
A dot appears in the upper left hand corner of the display
indicating that the time shown is P.M.
ALARM ON INDICATOR
A dot appears in the lower left hand corner of the display
indicating that the alarm has been set.
SETTING THE TIME
• Press and hold the TIME SET button and press the
HOUR button to set the hour.
• Press and hold the TIME SET button again and press the
MINUTE button to set the minutes.
SETTING THE ALARM
• Press and hold the ALARM SET button and press the
HOUR button to set the alarm hour.
•
Press and hold the ALARM SET button again and press
MINUTE button to set the alarm minutes.
•
Slide the ALARM ON/OFF switch to ON position.
SNOOZE REPEAT ALARM
When the alarm sounds, simply press the top of the clock
marked "SNOOZE" to deactivate the alarm. (The SNOOZE
activation buttons are located on the bottom of the clock).
The alarm will activate again after 9 minutes. This function
can be repeated again and again. To silence the alarm,
slide the ALARM ON/OFF switch to the OFF position.
BATTERY BACKUP
In the event of a power failure, this unit will automatically
switch to a battery stand-by circuit when a battery is
installed. Open the BATTERY COMPARTMENT on the bottom
of the unit and install a 9-volt battery (not included). Under
battery operation, the clock will keep the time running and
the alarm will sound at the preset time. Only the clock display
will not light to save battery energy. If you have a long power
failure you may need to make a slight adjustment to the
clock time after AC power returns. The clock uses an internal
battery powered clock circuit that is less accurate than the
power line frequency. Just follow Setting The Time
instructions, the alarm time will remain correct.
1
4
CONTROL LOCATIONS
1) Snooze Button
2) Hour Button
3) TIME SET Button
4) ALARM ON/OFF Switch
5) Minute Button
6) ALARM SET Button
CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE THIS
(POLARIZED) PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN
BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
THE SOURCE WARRANTY
The Source warrants that this product will be free from defects in
materials and workmanship for a period of ninety (90) days from
the date of purchase. Within this period, simply take the product
and your proof of purchase to any The Source store or dealer and
the product will be repaired without charge for parts and labour.
The Source reserves the right to charge for transportation. Any
product which has been subject to misuse or accidental damage
is excluded from this warranty.
This warranty is only applicable to a product purchased through
The Source company owned stores and dealers and to a product
that is presented for repair in a country where The Source offers
the product for sale. While this warranty does not confer any legal
rights other than those set out above, you may have additional
statutory rights which will vary under the laws of the various
countries, states, province and other governmental entities in
which The Source operates. This warranty is subject to all
statutory rights you may have in the country of purchase.
Imported by:
The Source,
Barrie, Ontario, Canada, L4M 4W5
Manufactured in China
For product support please visit
www.thesource.ca
Please Recycle
Recyclez
8003560
3
6
5
2
LIMITED WARRANTY
Limited Warranty
©2012 The Source .
All Rights Reserved.