Environmental Protection - EDM Product 08709 Manuel D'instructions

ROTARY TOOL KIT 170W
Switching On/Off (Pic. 8)
1. Hold the tool firmly and ensure your fingers are well away from moving parts.
2. Switch on by pressing the on/off switch to the "I" position.
3. Switch off by pressing the on/off switch to the "O" position.
Variable speed control (Pic. 9)
1. To adjust the speed, move the speed dial forwards or backwards.
2. The greater the number displayed, the faster the speed.
3. Different types of accessories require different speeds.
Note: The speeds quoted are for guidance purposes only.
Important! Working on a high load whilst at low speed can cause motor burnout.
Carbon Brushes
The carbon brushes are an integral component in the efficient running of the motor. These are consumable spare parts that
must be replaced when they are worn to 4mm.
NOTE: Worn carbon brushes should only be installed by an authorised power tool repair agent.
After replacing the carbon brushes there may be increased sparking. This is normal and should pass after a short period of time.
After new carbon brushes have been installed, run the Mini‐Grinder off load for several minutes to allow the new brushes to bed
in before use.

Environmental Protection

This product is marked with the selective sorting symbol on waste electrical and electronic equipment. This means
that this product should not be disposed of with household waste but must be supported by a collection system in
accordance with Directive 2012/19/UE. It will then be recycled or dismantled to minimize impacts on the
environment, electrical and electronic products are potentially hazardous to the environment and human health due
to the presence of hazardous substances.
EN INSTRUCTION MANUAL
REF. 08709