Satco NUVO LIGHTNING 60/2201 Instructions De Montage

NOTE:
Please consult a qualified electrician if you are not certain of the installation.
CAUTION:
Before starting the installation, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box. Use silicon caulking to seal between wall plate and wall. Leave
bottom unsealed so moisture can drain out.
1. Place the glass into metal shade firmly.
2. Install bulb. (Included).
3. Cover the top cover on the metal shade and fasten the top cover using lock screws and rubber washer A.
4. Fasten cross bar to the outlet box using 2 outlet box screws.
5. Tie ground wire from outlet box and from fixture to the ground screw on the cross bar. Connect white wire
from fixture to white wire (neutral wire) from supply circuit. Connect black wire from fixture to black wire
(live wire) from supply circuit. Cover connections using provided wire connectors.
6. Carefully tuck all wiring back into outlet box. Place the wall plate onto the wall until mounting screws
protrude out from the wall plate, place the rubber washer B to the mounting screw and secure the fixture
using lock nuts provided. Screw the short or long tail onto the bottom of nipple.
7. Turn on the power. The photocell will automatically light on from dusk to dawn and will
automatically light off from dawn to dusk.
ASSEMBLY INSTRUCTION
SKU#60/2201/2202/2203
A Satco Product