Télécharger Imprimer la page

Safety Instructions - Etherma ET-DESK-DIMM Notice De Montage Et D'utilisation

Publicité

Les langues disponibles
  • FR

Les langues disponibles

ETHERMA ET-DESK-DIMM
Connection cable with dimmer & timer (EN)
Installation and usage instructions
Version: 03/2020

SAFETY INSTRUCTIONS

• The device may only be operated in its original,
unmodified, and technically perfect condition.
All protective devices must operate faultlessly
and be freely accessible.
• Children under the age of 3 should be kept
away unless under constant supervision. Chil-
dren between the ages of 3 and 8 may only
switch the device on and off if they are super-
vised or have been instructed regarding safe
use of the device and understand the result-
ing risks, as long as the device is placed or
installed at its normal place of use. Children
between the ages of 3 and 8 may not plug the
device in, control the device, clean it and/or
carry out maintenance.
ETHERMA
Elektrowärme GmbH
Landesstraße 16
A-5302 Henndorf
T +43 (0) 6214 / 76 77
F +43 (0) 6214 / 76 66
office@etherma.com
www.etherma.com
INSTALLATION
• Remove the connection cable supplied with
the LAVA
DESK 2.0.
®
• Plug the ET-DESK-DIMM connection cable
into the connection socket on the device.
• The LAVA
DESK 2.0 infrared heater can now
®
be controlled with ET-DESK-DIMM.
SETTING HEAT
• Press ON/OFF to set the heating level
• Press ON/OFF repeatedly to go through the
settings :
• HIGH: red light – 100 % heat output
• MIDDLE: green light– 66 % heat output
• LOW: blue light – 33 % heat output
• OFF
OPERATING TIMER
• Keep ON/OFF pressed in order to activate the
timer.
• Press the ON/OFF button until the LED light
flashes.
• Then you can chose between the following set-
tings by repeatedly pressing ON/OFF:
• LED blue: 1 hour
• LED yellow: 2 hours
• LED red: 3 hours
• If no button is pressed for a few seconds, the
mode automatically returns to the normal
heating state.
• If you want to deactivate the timer, switch off
the heating element with the ON/OFF button.
ATTENTION: The manufacturer shall
not be held liable if these notices and
instructions are not complied with.
Devices may not be used improperly
i.e. for purposes other than the in-
tended use.

Publicité

loading