Samsung RS68A Serie Manuel D'utilisation page 29

STEP 2 Spacing (applicable models only)
STEP 3 Flooring
NOTE
If the refrigerator cannot pass through the entrance due to its size, see the Door removal
for entrance section in the Installation chapter.
Untitled-34 29
1. Open the door and locate the provided
spacer.
2. Unpack the spacer and attach it to the
rear of the refrigerator as shown. It
helps ventilate air to the rear wall and
save power consumption.
• The surface to install the refrigerator
must support a fully loaded refrigerator.
• To protect the floor, put a large piece
of cardboard on each leg of the
refrigerator.
• Once the refrigerator is in its final
position, do not move it unless
necessary to protect the floor. If you
have to, use a thick paper or cloth such
as old carpets along the movement
path.
English 29
2021-01-26 7:00:56