Samsung NK36M5070FS/UR Instructions Pour L'installation Et Mode D'emploi page 27

Operation
T1. ON/OFF Suction motor:
When hood is on, it switches off at any speed by pressing button T1.
When the hood is off, it switches on at Speed 1 by pressing button T1.
T2. Speed decrease
Press "T2" button to decrease the speed from 4 (Boost) to 1.
T3. Speed increase
Press the button (hood is ON) to increase the the speed of the motor from speed 1
to the Boost speed (timed).
Speed 1 LED L1
Speed 2 LED L2
Speed 3 LED L3
Boost (timed) LED L4 flashing
Note: Speed 4 (Boost timed) remains activated for 5 minutes, after which the hood
sets speed 2 automatically
T4. Speed timing
Speed timing is activated by pressing T4 button, when timing is up the hood
switches off.
Timing is divided as follows:
Speed 1 - 20 minutes (LED L1)
Speed 2 - 15 minutes (LED L2)
Speed 3 - 10 minutes (LED L3 )
Boost - 5 minuts (LED L4 flashing)
During timed operation press T2 button and the hood quits the timed mode and
decreases the speed.
Press T3 button and the hood quits the timed mode and increases the speed.
Press T4 button and the hood quits the timed mode maintaining the set speed.
T5. Lights ON/OFFF
Press the Light button and the lamps will turn on
Press the Light button again and the lamps will turn off.
Filter saturation signal button – Control and Configuration:
Grease filter signal
After 40 hours of operation LED L1 flashes.
When such signal appears, carry out grease filter maintenance.
To reset the signal, keep T1 button pressed for 3". (hood is ON).
LED L1 stops flashing before the hood goes back to OFF.
Charcoal filter signal
After 160 hours of operation LED L2 flashes.
When such signal appears, carry out charcoal filter maintenance.
To reset the signal, keep T1 button pressed for 5". (hood is ON).
LED L2 stops flashing before the hood goes back to OFF.
In case of contemporaneous signalling of both filters, LEDs L1 and L2 flash jointly.
To reset, carry out the procedure described above for 2 times.
The first time it resets the charcoal filter signal, the second time it resets the grease
filter signal.
The charcoal filter signal is not active in the standard mode.
In case the hood is used in filter version it is necessary to enable the charcoal filter
signal.
Activating charcoal filter signal:
Set the hood to OFF and press T2+T3 button for 3".
Once the button has been pressed, LED L1 flashes for 1".
LEDs L1 and L2 flash until the hood gives out a "BEEP", as confirmed activation, and
goes back to OFF.
Deactivating charcoal filter signal:
Set the hood to OFF and press T2+T3 button for 3".
Once the buttons have been pressed, the LEDs L1+L2 flashes for 1".
The hood gives out a "BEEP" and LED L2 switches off.
LED L1 flash until the hood gives out a "BEEP", as confirmed disactivation, and goes
back to OFF.
27