Vinsetto 920-072V80 Manuel D'assemblage Et D'instructions page 5

Step 3:
3.1 As shown in Figure 1 , insert the hexagonal bar into the table leg A until the buckle is not
visible.
3.2 Assemble the other end of the connecting rod to the table leg B and screw on the handle.
The handle does not need to be tightened. Note: As shown in Figure 2 below, it needs to be
aligned with the card slot.
3.3 Pull the connecting rod with the handle to the bottom end of the table leg A in the direction
of the arrow as follows.
3.4 Tighten the handle and install the M4 screws.M4 screws using the supplied screwdriver .
H
2
On the card slot
2
Step 4:
4.1 Lay the table board flat and put the table shelf on it.
4.2 After connected two desk top with pins and put on the frame and tightened with M6 screws,
put on the hand handset.M6 screws using the supplied spanner .
4.3 The hand controller is fastened to the table with self-tapping screws.Self-tapping screws
using the supplied screwdriver .
4.4 Conect the power cord and motor of the
I
3
H H
1 2
Notice: please preload all the
screws into the holes first and
then fasten them up.
K
1
H
2
G
2
J
Same side
F
Tightened
3
L
power supply
I
2
L
I
1
J
H
1
handest as show in the figure.
I
1
I
I
1
H
2
K
3
I
2