Setting The Time Manually - OWIM Auriol HG03895 Instructions D'utilisation Et Consignes De Sécurité

Within 4 minutes, the hands will move to 12 o'clock. The radio signal reception
is initiated once all the hands have moved to the 12 o'clock position. After 3 -
10 minutes, the clock will receive the signal and set itself to the exact time.
The reception of the DCF / MSF radio time signal by the wall clock can also be
started manually.
Press and hold the REC button
to receive the DCF / MSF radio time signal. This process takes a few minutes to
complete.
Note: If the wall clock was not able to receive the DCF / MSF radio time signal
because of errors, e.g. due your location to being at too great a distance from the
transmitter or for other reasons, you can set the time manually. The manually set
value is overwritten as soon as reception of the DCF / MSF radio time signal is
successful.
Note: For products in tended for Romania, Cyprus, Bulgaria and Greek, the
display stops at "01:00".
Note: For products in tended for the United Kingdom, Ireland and Portugal, the
display stops at "11:00".
˜ Setting the time manually
Press and hold the M.SET button
switches into manual mode.
Press and hold the M.SET button
position for you to set the time.
Briefly pressing the M.SET button
steps to enable you to set the current time manually.
12 GB/IE/NI
at least 5 seconds. The wall clock attempts
3
at least 3 seconds. The wall clock
4
again until the hands reach the correct
4
moves the hands forward in one minute
4