Batteries; Maintenance; Burner Cover Assembly - Ashley Signature Design P456-776B Instructions De Montage

Make sure the control knob is in the "OFF" position. Unscrew
the push button cap on the ignition module located on the
control panel to access the battery compartment. The ignition
module requires one AAA size battery. See Figure 9.
The flames should look like those in Figure 10 To clean the burner,
use a soft brush after the burner and lava rocks have cooled
completely. Never use a vacuum cleaner on the lava rocks. It is
recommended that the lava rocks be stored indoors during the
winter if they will be subjected to freezing temperatures. The
propane cylinder must be disconnected and removed from the
appliance before the appliance can be stored indoors.
Place the burner cover on the table top as shown in Figure11.
WARNING: BEFORE PLACING THE BURNER COVER ON, MAKE SURE THE FIREPIT
HAS BEEN SHUT OFF AND THE BURNER HAS COMPLETELY COOLED DOWN.
Cover must be removed when burner is in operation
Le couvercle doit être enlevé si le brûleur fonctionne
Se debe retirar la tapa cuando el quemador está en funcionamiento
P456-776B/T
All manuals and user guides at all-guides.com

BATTERIES

MAINTENANCE

BURNER COVER ASSEMBLY

Figure 11
. .
( 1 5 V )
IGNITOR
AAA BATTERY
Allumeur
COMPARTMENT
( )
INSTALL - SIDE
FIRST
(1.5 V)
Installer AAA
compartiment
de la batterie (-)
premier côté
Figure 9
Figure 10
Page 11 of 12