Operation On Artificial Grass; Cleaning; Storing - Gartenmeister GMXB1020-2 Mode D'emploi

Operation on artificial Grass

For usage on artificial grass to lift the fibres in an upright position, first
adjust the speed adjusting wheel (3) to level 4 – 5.
1. Position the device on the artificial grass and switch on by pressing the
safety button first and then ON/OFF trigger. Release the safety button
after triggering.
2. Pull the device towards the operator and let it roll away from the
operator by the force of the brush itself.
3. Repeat these movements while moving across the artificial grass.
For artificial grass, the rough dirt blue brush, article no. 89 36 95 is
best.

Cleaning

 Always pull the power plug before undertaken maintenance work on the
device.
 If lumps of earth or plants are stuck in the brush roller while working,
first turn off the device. Start the motor only for a moment. The block-
age will be cleared by the movement of the brush roller.
 Should it be necessary to loosen the dirt by hand, first disconnect the
power cord for your safety.
 Use a stiff brush and a dry cloth to clean the device; do not use
aggressive chemicals or abrasives for cleaning.
 Do not allow liquids of any kind to enter the device.

Storing

 Clean the device before storing it.
 Before storing check all parts and the power cable for damages.
 Store the device indoors in dry place that is protected from dust and dirt
and extreme temperatures.
Operation
15