BIN WAREHOUSE 65002 Instructions D'assemblage page 2

FRONT GRID ASSEMBLY
#1
#2 #4 #5
PARTS NEEDED:
4 of #1 2 of #2
1 of #4 1 of #5
REAR GRID ASSEMBLY
#1
#2
#3
PARTS NEEDED:
4 of #1 2 of #2
2 of #3
SLIDE RAIL ASSEMBLY TO REAR GRID
#8
PARTS NEEDED:
12 of #8
Top Top
#1
#1
Alignment dimples
#1
#2 #2
Holes down
#1
Short side to floor
STEP 1
4 Horizontal crossbars (#1) inserted through 2 Center
Vertical (#2) Tip : When installing second center vertical,
stand assembly with horizontal crossbars placed on
floor and push down second center vertical alignment
dimples.
Top
#1
#1
Alignment Dimples
#1
Holes up
#2 #2
#1
Short side to floor
STEP 1
2 Center Verticals (#2) on 4 horizontal crossbars (#1).
Tip : When installing second center vertical, stand
assembly with horizontal crossbars placed on floor and
push down second center vertical alignment dimples.
Top
#8
STEP 1
12 Horizontal slide rails (#8) inserted in rear grid.
Tip: If necessary, tap horizontal slide rails to be
sure slide rails are fully inserted.
Other side
#4
STEP 2
1 Left front corner vertical (#4) and 1 right front
corner vertical (#5) Placed on horizontal crossbar.
#3
Other side
STEP 2
2 Left and right rear corner verticals (#3) placed
on horizontal crossbars.
STEP 2
Fastening all 12 horizontal slide rails (#8) in rear
grid using 12 #08 x ¾ in. fastening screws (#1).
Note: Fastener in bottom hole only
#5
Point all dimples down
Holes down
Alignment Dimples
#3
Fasten from bottom
hole only
Short side down