Flex LE 12-3 100 WET Notice D'instruction D'origine page 23

LE 12-3 100 WET/L 12-3 100 WET
Setting
1
2
3
4
5
6
Remove the bail handle
Remove the bail handle if required.
 Undo screws (1.) and remove the bail
handle (2.).
 Attach the handle cover with plastic
screws (3.).
The power tool can now be used without the
bail handle.
Operating instructions
klqb
tÜÉå=íÜÉ=ÖêáåÇÉê=áë=ëïáíÅÜÉÇ=çÑÑI=íÜÉ=ÖêáåÇáåÖ=
íççä=ÅçåíáåìÉë=êìååáåÖ=ÄêáÉÑäóK
 When using the power tool, wear rubber
gloves.
 Attach sanding tool.
Speed (r.p.m.)
1200
1700
2200
2700
3200
3700
 Connect machine to the power supply.
 Connect the water.
 If required, adjust speed to the task
(LE 12-3 100 WET only).
 Switch on the machine.
 Open shut-off valve on the water connection.
 Applying light pressure, place the grinding tool
on the material to be processed. Excessive
pressure will increase the wear on the grinding
tool and impair the grinding result.
 The grinder can be used for horizontal and
vertical work.
 Hold the power tool in such a way that water
cannot run into the ventilation slots.
Maintenance and care
t^okfkd>
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
Regularly clean the power tool and ventilation
slots. Frequency of cleaning is dependent
on the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
Carbon brushes
The electric power tool features cut-off carbon
brushes. When the cut-off carbon brushes
reach their wear limit, the electric power tool
switches off automatically.
23