Hiland HLDS01-CGTHG Guide D'utilisation page 10

ASSEMBLY INSTRUCTIONS
9. Assebmly the protective guard and mesh
Insert the hooks of protective guard (F) to the
holes of upper supports (E).
Put the mesh (B) on the top plate (D). Make sure
the screw holes align the holes of top plate (D).
Use Phillips screwdriver (LL) to secure the
mesh (B) and protective guard (F) to the top
plate (D) with M5 x 12 mm screws (DD) and
fixing bracket (FF).
Hardware Used
M5 x 12 mm Screw
DD
Fixing Bracket
FF
Phillips
LL
Screwdriver
10. Use Phillips screwdriver (LL) to install
side panels (H) to bottom of assembly with
M5 x 12 mm screws (DD).
Note: Do not cover the panel where the
magnet is.
Hardware Used
DD
M5 x 12 mm Screw
Phillips
LL
Screwdriver
9
x 3
x 3
x 1
10
x 12
DD
H
x 1
10
F B
FF
DD