Télécharger Imprimer la page

Fortin EVO ONE Schéma D'installation page 5

Installation régulière. addenda - schéma de branchement suggéré pour mazda 3 - axela 2010-2013. compatible avec véhicule à transmission automatique seulement.
Masquer les pouces Voir aussi pour EVO ONE:

Publicité

This guide may change without notice. See www.fortin.ca for latest version.
Ce guide peut faire l'objet de changement sans préavis. Voir www.fortin.ca pour la récente version.
KEY BYPASS PROGRAMMING PROCEDURE 3/3 | PROCÉDURE DE PROGRAMMATION CONTOURNEMENT DE CLÉ 3/3
8
CAUTION The following step must be completed within 5 seconds.
back to step 1.
ATTENTION
5 sec. max
connecteurs et
AUTOMATIC TRANSMISSION
TRANSMISSION
Activate the remote
starter.
les prochaines étapes doivent être complétées en moins de
allez
à l'étape 1.
AUTOMATIQUE
CONTINUED NEXT
Actionnez le démarreur à
distance.
FLASH 10X
FLASH
10X
ON
OFF
IGNITION
IGNITION
OFF
Manual transmission:
Remove
the jumper.
Transmission manuelle:
Retirez
le fil (jumper).
Otherwise disconnect
MANUAL TRANSMISSION
TRANSMISSION
x1
PRESS
PA
RELEASE
Press and hold the
programming button until
the LED flashes once
than release the
programming button.
 The RED LED will
flash once (1x).
9
Using a jumper
power
wire, apply
(12v) to the
vehicle's ignition1.
10
The RED LED will flash
Flash
rapidly ten (10) times and
after the BLUE LED will
flash rapidly.
OFF
If the LED is solid RED
disconnect the 6 Pin
connector (Main-Harness) and
go back to step 1.
11
MANUAL TRANSMISSION
TRANSMISSION
Remove the jumper.
12
The BLUE LED will turn off.
The module is now
programmed.
Use the remote of the remote
starter or security system to test
all of the supported features to
ensure proper programming.
all connectors and go
5 secondes.
Si non,
débranchez
MANUELLE
PRESS X1
FLASH X1
PAGE SUIV ANTE
Pesez et garder appuyé
bouton de programmation
jusqu'à se que le DEL
clignote une fois et
relâcher
le bouton.
 La DEL ROUGE
clignote 1 fois.
Ignition1
À l'aide d'un fil
appliquez
(jumper)
12v
sur l'ignition1
12V
du véhicule.
La DEL ROUGE clignotera
dix (10) fois rapidement et
le ensuite DEL BLEU
clignotera rapidement.
Si le DEL est ROUGE solide
débranchez le connecteur 6
pins (Connecteur principal) et
allez à l'étape 1.
MANUELLE
Ignition
Retirez le fil (jumper).
La DEL BLEU s'éteint.
Le module est
programmé.
Testez toutes les fonctions
supportées sur le véhicule avec la
télécommande du démarreur à
distance ou du système de sécurité.
5 / 9
Page
tous les
le

Publicité

loading