Publicité
Les langues disponibles
Les langues disponibles
Once poles are assembled, select the groove (spaced in 1" increments) where you'd like your lowest shelf to rest.
Position the two halves of your shelf clip (E) so that the beveled edge is facing the top. Snap the clip together around the
pole and adjust until you feel it locate the groove. Once clips are snapped into place at equal heights on each of the 4
poles, slide a shelf down from the top to rest on the clips. Gently tap with a rubber mallet if needed to secure shelf.
If having difficulties getting the shelf
into place, use a rubber mallet. Use
only a rubber mallet to avoid damage.
With the unit fully assembled, press a plastic cap (F) into the hole in the top of each pole. To level your assembled unit,
The designs, images, artwork, product descriptions and data shown in this document are protected by U.S. and foreign patent, copyright, trade dress and contract law and may not be copied, imitated,
duplicated or used in any manner other than as herein proposed. Design Ideas o ers these materials to viewer solely for the purpose of allowing viewer to reference assembly or care instructions for the
depicted products purchased from Design Ideas. By viewing them, viewer agrees to this restriction and not to any other use of same whatsoever. Any other use or further distribution of the shown designs,
images, artwork, text and/or data by viewer or further recipients of same is strictly forbidden. Design Ideas, Ltd. will enforce its intellectual property rights in this material to the fullest extent of the law.
Designs and contents copyright 2017 Design Ideas, Ltd. DESIGN IDEAS and other trademarks are registered and/or owned by Design Ideas, Ltd.
Repeat with remaining clips and shelves, working your way to the top.
Shelf Clip (E) Assembly
adjust the feet by twisting to the desired height.
Step 2
A
E
E
Step 3
E
Publicité
