Publicité
Step 11
Step
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (E2) and lay it over your unit.
Make equal margins along all four edges of the BACK (E2). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (E2) to your unit using the NAILS (1N).
å
Fasten two TIE PLATES (3G) to the PLINTHS (R2) and BASE (G).
å
Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
Page 16
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
E2
R2
411836
Caution
NAIL
(34 used in this step)
G
3G
BLACK 9/16" LARGE HEAD SCREW
(4 used for the TIE PLATES)
www.sauder.com/services
1N
R2
1S
Publicité
