boon Flair Instructions page 3

assembly
1
NoTe: DO NOT REMOVE the sticker holding the seat
base cover in place until after support tube has been
inserted into base.
Make sure seat base cover remains on support tube.
Insert support tube into base.
4
Raise tube to highest position by stepping on height
adjustment button.
Place seat on seat base aligning back of seat with brake
pedal. The front of the seat will face in the direction of
the height adjustment button. Secure with (5) M6 bolts.
imPorTaNT: The seat MUST be aligned with its BACK
toward the brake pedal for proper assembly.
2
Rotate the tube clockwise while gently pressing down
until the tube drops into place and can no longer rotate.
Brake pedal
3
To ensure that tube is secure, first try to rotate tube counter-
clockwise. Tube should not be able to rotate. Second, try to
pull tube up out of the base. The tube may move upwards
slightly, but should remain attached to the base.
Remove the sticker holding the seat base cover in place
and discard it properly.
5
Align seat base cover with notch toward front of seat.
Attach seat base cover with (2) M4 bolts.
3