Maintenance And Cleaning; Technical Features - Girmi RC55 Manuel D'utilisation

Before you recharged, completely discharged the battery.
When the unit is not in use for a long period (2 months), it is recommended to let it charge for about 2 hours
before using. In any case it is advisable to fully discharged the battery before recharging.
I seguenti accorgimenti preserveranno la durata della batteria.
If the appliance, even after a recharge, works only if it is connected to the adapter, it is possible that the
battery is no longer capable of delivering enough power to the unit. In this case, please contact an authorized
service center.

MAINTENANCE AND CLEANING

Disconnect the clipper from the power adaptor, and unplug it from the power outlet before
starting any cleaning operations.
After each cut, always clean used comb (7) and cutting blade (1) by blowing over them or using the small
brush (9). Periodically lubricate the blade by following the steps below.
Open the flap (2) placed beneath the cutting blade, pushing the blade as shown in figure below. Remove
remaining hair by blowing or using the small brush (9).
Use lubricating oil (10) for the blade. 2 or 3 drops are enough if this operation is carried out frequently.
As shown in the figure, two points must be lubricated with oil:
Put 1-2 drops on the blade (white ceramic). Put 1-2 drops on the driveshaft joint.
Use only the provided oil or similar oil without acids.
Replace the cover by following the next steps:
- CAUTION: before assembling the cover, bring the cutting height regulator
(3) at 2 mm, as the assembling is easier in this way.
- Insert the tab (B) in the joint (A), as shown in fig. 1.
- Push the door (2) towards the clipper body until it clicks in position (fig. 2)
Clean the main body by using a soft damp cloth, never immerse the unit in water or other liquids.

TECHNICAL FEATURES

•
AC/DC Adaptor: IN AC 230V, 50Hz, OUT DC 5V – 1000mA
•
Charging light
•
Cutting height adjustment - Ceramic cutting blade, titanium fixed blade
•
Litium battery, 600mAh, with fast charging: 2 hours
•
Accessories: 4 combs, AC/DC adaptor, lubricating oil, small brush
TECHNICAL SHEET POWER SUPPLY: LW-050100EU
Information
Input voltage
Input AC frequency
Output voltage
Output current
Output power
Average active efficiency
No-load power consumption
Value
100 - 240
50/60
5.0 a.C.
1.0
5.0
74.66
0.68
Unit
V
Hz
V
A
W
%
W
12