Publicité
Les langues disponibles
Les langues disponibles
FUNCTION & OPTIONS
The infrared sensor to achieve tri-level dimming control, for some areas that require a light change notice before switch off.
It differs 3 levels of the light control: 100% -- dimming light (0, 10%, 30%, 50%) – off; and 2 periods of selectable waiting time:
motion hold-time and stand-by time. Selectable daylight threshold and choice of detection area.
PARAMETER SETTING BY DIP SWITCH
Detection range can be reduced by selecting the combination on the DIP
switches to fit precisely to each application
The lamp can be set to stay ON for any period of time between
approximately 10 seconds and a maximum of 15 minutes. Any movement
detected before the time elapse will restart the timer. It is recommended to
select the shortest time for adjusting the detection zone and for performing
the walk test. Switch location and hold time of the corresponding table is as
follows:
Energy Efficient Lighting Limited | www.eelighting.ca | Tel: 1-855-415-8878
INSTALLATION INSTRUCTIONS
SMI1503 - HIGH BAY SENSOR
The chosen lamp response threshold can be infinitely from approximately
10-50lux, switch location and light-control of the corresponding table is as follows:
The corresponding file of switch location and stand-by level as follows:
R201019-1000
Publicité
