Panasonic TH-46PZ850U Manuel D'utilisation page 37

Check that the network settings are as shown below, and then start "Connection test".
Select "Connection test" and press OK.
*Press OK again to cancel the test.
(It takes a while to cancel the test.)
Network setting
Connection test Succeeded
IP setting mode Manual
IP address 192.168.0.5
Sub netmask 255.255.255.0
Default gateway 192.168.0.254
Select "IP setting mode" and set to "Automatic".
(When IP automatic acquisition in DHCP can be used)
Network setting
Connection test Succeeded
IP setting mode Automatic
IP address 192.168.0.5
Sub netmask 255.255.255.0
Default gateway 192.168.0.254
The acquired address is displayed.
Each IP address is acquired automatically.
Select "DNS setting mode" and set to "Automatic".
(When DNS automatic acquisition in DHCP can be used)
Network setting
DNS setting mode Automatic OK
Primary DNS 192.168.0.20
Secondary DNS 192.168.0.21
LAN d tti M l
The acquired address is displayed.
Each IP address is acquired automatically.
If you are using a broadband router, IP automatic
acquisition in DHCP can be used under normal
circumstances. If you are not sure, check with the
person who installed the equipment, or check the
instructions of each device.
Select "LAN speed setting" (Default is "Automatic")
Network setting
DNS setting mode Automatic OK
Primary DNS 192.168.0.20
Secondary DNS 192.168.0.21
LAN speed setting Automatic
LAN speed 10BASE half duplex
Select "Software update"
Network setting
DNS setting mode Automatic OK
Primary DNS 192.168.0.20
Secondary DNS 192.168.0.21
LAN speed setting Automatic
LAN speed 10BASE half duplex
Software update
The network settings become effective when you close the menu and run "Connection test".
select
1/2
ok
1/2
select
ok
select
2/2
ok
select
2/2
adjust
select
2/2
ok
Succeeded: "Connection test" succeeded
Failed: Check the broadband environment connection
and settings and the network settings, and then
perform the test again.
Test in progress
---: Test not yet performed
■
Manual setting
Select "IP setting mode" and set to "Manual"
Select the item and press OK
Check the specifications of the broadband router and
enter each IP address.
Sub netmask 10I OK
or
■
Manual setting
Select "DNS setting mode" and set to "Manual"
Select the item and press OK
Enter each IP address as was specified by the
provider.
Primary DNS 10I
or
Normally, select "Automatic".
If "Connection test" failed, set the "LAN speed setting"
to "manual" and then select "10BASE half duplex",
"10BASE duplex", "100BASE half duplex" or "100 BASE
duplex".
Cannot be selected when the "LAN speed setting" is
"Automatic".
Changing the settings may make it impossible to
connect some types of equipment.
Press OK to start the software update screen.
Follow directions of the screen.
* Set "Clock" first. (p. 15)
change
channel
ok
select
ok
37