DOREX Tecnica Design Instructions D'installation

1. DETERMINE HANDING OF YOUR DOOR
(1)
DOOR SWINGS
INTO ROOM
LEFT HAND DOOR
2. MARK DOOR
3. INSTALL DUMMY LEVER
1. Dummy:
Surface Mounted
ALLEN-KEY SCREW
WOOD SCREWS
ROSE CHASSIS
- Pre-drill and install rose-chassis using supplied
wood screws.
- Install rose on the rose-chassis.
- Install lever on rose chassis shaft and secure
with allen-key screw.
TEMPLATE
Align with door edge
(2)
DOOR SWINGS
INTO ROOM
RIGHT HAND DOOR
EXTERIOR
a. Position the horizontal center line of the
template at the height of 36"
from the finished floor, fold template on
(965mm)
the corner of the door and mark the center of
the dummy lever on the door edge.
2. Dummy:
Thru-bolt
LEVER
THRU-NUT
ROSE
THRU-BOLT & WASHER
- Drill 5/16" diameter through hole,
(8mm)
fit thru-nut into rose chassis. Install
rose-chassis using thru-bolt with cup washer on
the inside side of the door.
- Pre-drill and install wood screw.
- Install rose on the rose-chassis.
- Install lever on rose chassis shaft and secure
with allen-key screw.
BACKSET 2 3/4"
BACKSET 2 3/8"
DUMMY LEVER CENTER
CAUTION: Prior to using template, verify that the template is to full scale by measuring any one of the backset dimensions.
Stand on the exterior, outside the room, facing the door
(1) The door is left hand door if hinges are installed on your left and
door swings into the room
(2) The door is right hand door if hinges are installed on your right and
door swings into the room
b. Select 2 3/8"
or 38" and mark center of the dummy lever on the face of the door.
(914mm)
c. Mark the dummy lever mounting holes on the door for the
appropriate type of dummy lever installation using the
dummy lever as a template. Ensure lever is centered on the
marked center.
LEVER
ALLEN-KEY SCREW
ROSE
WOOD SCREW
SQUARE ROSETTE
ROSE CHASSIS
ALLEN-KEY SCREW
LEVER
(70mm)
(60mm)
DUMMY LEVER INSTALLATION
INSTRUCTIONS & TEMPLATE
or 2 3/4" backset as desired
(60mm) (70mm)
3. Dummy:
Back to Back
THRU-BOLTS
INTERIOR
ROSE-CHASSIS
ROSE
- Drill 5/16" diameter through holes, fit thru-nuts into
(8mm)
exterior rose-chassis.
- Install rose on the rose-chassis.
- Mount the exterior rose-chassis on the exterior door surface.
- Mount the interior rose-chassis in the interior door surface and
attach them using the supplied thru-bolts and cup-washes on the
inside side of the door.
- Install lever on rose chassis shaft and secure with allen-key screw.
36"
(914mm)
from finished floor
LEVER
ALLEN-KEY SCREW
ROSE
THRU-NUTS
EXTERIOR
ROSE CHASSIS
or 38"
(965mm)
100-TEC-DUM 2022/07