Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Installation
DOWNDRAFT
Install the top mounting brackets using the #4 sheet
1
metal screws provided. Refer to the illustration below.
Install the lower mounting brackets using the #8 x 32
2
sheet metal screws provided, but do not tighten. The
brackets will need to be adjusted once the downdraft is
placed in the opening. Refer to the illustration below.
Top mounting bracket.
Bottom leveling bracket.
TRANSITION
For internal blowers, remove the existing 10"
transition. Refer to the illustration below.
For in-line and remote blowers being discharged from the
front, leave the 10"
round transition in place.
(254)
For in-line and remote blowers being discharged from the
rear, remove the 10"
round transition from the front and
(254)
solid cover from the rear of the downdraft, then reinstall the
10"
transition on the rear and solid cover on the front.
(254)
Remove transition.
round
(254)
|
wolfappliance.com
7
Publicité
Table des Matières
