Heatrex 240 Serie Instructions D'installation

Select a heater installation location where the outlet air is not directed at an adjacent wall.
A. Radial Diffuser:
1. Loosen sheet metal screws located in the side of the heater cabinet to free directional louvers. Do not remove. Reference
Figure 1 below for location.
2. Remove directional louvers and retighten sheet metal screws from step 1.
3. Using the 8 supplied sheet metal screws, mount radial diffuser in pre-punched holes located in the heater cabinet as shown in
Figure 2.
4. Adjust louvers to direct airflow as desired.
B. Anemostat Diffuser:
1. Remove sheet metal screws and directional louvers as shown in Figure 1.
2. Remove front cabinet panel. See Figure 3 for attachment screw locations.
3. Using the supplied bolts, nuts and lock washers, install anemostat diffuser into the pre-punched holes in front panel.
4. Reinstall front heater cabinet panel.
INSTALLATION INSTRUCTIONS-
DIFFUSER ACCESSORY KITS
240 Series Electric Unit Heater
Accessory kit installations should be performed by a qualified electrician.
Disconnect all power supplies before working on equipment.
Cabinet Size
(Reference heater nameplate)
1
2 & 3
4
WARNING
Radial
Diffuser Kit
HX-1024152
HX-1024153
HX-1024154
Anemostat
Diffuser Kit
HX-1024155
HX-1024156
HX-1024157
HX24-2241-83-1EF