Publicité
Les langues disponibles
Les langues disponibles
C8SR10 Series – LED Steel Sortie Sign
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors.
2. Do not let power supply cords touch hot surfaces.
3. Do not mount near gas or electric heaters.
4. Equipment should be mounted in locations and at heights where it
will not readily be subjected to tampering by unauthorized personnel.
5. The use of accessory equipment not recommended by the manufac-
turer may cause an unsafe condition.
6. Do not use this equipment for other than intended use.
7. All servicing should be performed by qualified service personnel.
SAVE THESE INSTRUCTIONS
Installation Instructions
1. Turn off AC power.
2. Route AC supply wires into electrical box and leave 6" of wire length.
3. Remove exit face. To open the sign slide out the exit face and the
fibreglass diffuser (See Fig. 1).
4. Remove the appropriate chevron(s) on the exit sign by supporting the
exit face on either side of the chevron and carefully knock out with a
screwdriver from the rear (See Fig. 2).
Wall Mount
a. Knock out the proper hole pattern in the back plate to mount to
the standard junction box (including the large wire hole); place a
support on either side of the hole to be removed and knock out
with a screwdriver.
b. Feed AC supply leads through the center hole.
c. Mount the exit sign securely to the junction box using the junction
box screws (See Fig. 3).
Canopy - Ceiling or End mount
a. Determine desired mounting location of sign.
b. Remove the proper knockouts in the frame from the outside with
a hammer and screwdriver.
c. Route AC wires from exit through large knockout. For ceiling
mount, make sure backplate is mounted so exit face will be facing
in desired direction.
Emergi-Lite
Tél: (888) 552-6467 ext. 547 or 255
Figure 1
Part List
1. Junction box (not provided)
2. Spider Plate
3. Canopy
4. Housing
5. LED Strip
6. Junction box screws (not
provided)
7. Long Screws (2)
Figure 2
Figure 3
Fax: (888) 867-1565
www.emergi-lite.com
C8SR10 Series – LED Steel Sortie Sign
13
8. Back Plate (or second sor-
tie face)
9. SORTIE face
10. Coloured Diffuser
11. End Cap
12. End Cap screws (2)
13. Canopy screws/nuts (2)
12
10/07 750.1113 Rev. B
3/4
Publicité
