Mounting And Removing Flat Panel Screen; Cross Section - peerless-AV SmartMount ST635 Mode D'emploi

Mounting and Removing Flat Panel Screen

WARNING
• Always use an assistant or mechanical lifting equipment
to safely lift and position the flat panel screen.
• Do not tighten screws with excessive force. Overtightening
can cause damage to mount. Tighten screws to 40 in. • lb
(4.5 N.M.) maximum torque.
• Be careful not to pinch fingers when pushing screen from
the bottom.
3
Tension Adjustment of Ratchet Handle:
tension in adapter brackets (BB & CC) by rotating
ratchet handle. NOTE: If obstruction prevents ratchet
handle from rotating, pull handle out while turning will
allow handle to reposition without tightening. Release
and turn handle to tighten or loosen.
Mounting Screen: Ratchet handle must be in the up or
down position or interference will occur while hooking
adapter brackets to wall plate (AA). Slowly hook
adapter brackets (BB & CC) onto wall plate (AA) and
swing screen down as shown in fig. 3.1. Adapter
bracket hooks must fully engage wall plate as shown in
detail 1. Using phillips screw driver or security
driver (FF), turn safety/security screws on adapter
brackets (BB & CC) clockwise till screw tip securely
contacts wall plate as shown in cross section.
Screen Adjustment: Screen can be adjusted
horizontally by loosening safety/security screws on
adapter brackets (BB & CC) three full turns. Adjust
screen as shown in figure 3.2. Tighten safety/security
screws on adapter brackets till screw tip securely
contacts wall plate as shown in cross section.
Removing Screen: To remove screen from mount,
loosen safety screws, swing screen away from mount,
and lift screen off of mount.
Adjusting the Tilt Angle of the Flat
Panel Screen
4
For preset tilt angles use
angle use ratchet handle.
INCRELOK™: The screen can be locked into a
pre-set tilt position of -5°, 0°, 5°,
locator hole to find tilt position hole and tilt screen to
align holes. Tighten IncreLok™ tilt locking screws on
both adapter brackets to lock tilt as shown in detail 2.
Ratchet Handle: Loosen ratchet handle (refer to step
3 for tension adjustment of handle).
top or bottom of screen to adjust tilt as shown in figure
4.1. The tilt can be adjusted to a maximum of 15°
forward or 5° backward.
Adjust
Increlok™ and for custom tilt
10° or 15°. Use
Push or pull from
7 of 21
AA
BB
&
CC
DETAIL 1
AA
SAFETY/
SECURITY
SCREW

CROSS SECTION

IncreLok™
TILT LOCKING
SCREW
TILT
POSITION
HOLES
DETAIL 2
ISSUED: 02-18-08 SHEET #: 202-9249-4 09-02-08
RATCHET
HANDLE
BB
&
CC
fig 3.1
fig 3.2
LOCATOR
HOLE
RATCHET
HANDLE
fig 4.1