Napoleon GD800-KT Instructions D'installation

Inclusive in this kit for:
1 brick panel - right
1 brick panel - left
1 brick panel - rear
1 upper brick baffl e
1 hearth - right
1 hearth - left
1 hearth - centre
1. Remove the hearth strip / screen assembly and glass door.
(Refer to manual).
SECURING SECURING
SCREW SCREW
ANDIRON ANDIRON
/ GRATE / GRATE
MOUNTING MOUNTING
SCREW ( SCREW ( 2) 2)
X X
2. Remove the andiron / grate assembly by removing the 2
screws located behind the andirons.
3. Remove the right log bracket, as shown. Note the position
of the securing screw in the bracket.
4. Install the right, left and centre hearth bricks into the fi rebox,
as illustrated. The hearth should appear seamless across the
front. Ensure that a ¼" space exists between the hearth bricks
and the perimeter of the burner.
GD800-KT, GD806-KT & GD807-KT
DECORATIVE BRICK PANEL
I N S T A L L A T I O N I N S T R U C T I O N S
GD800-KT GD807-KT GD806-KT
Old Town Sand Stone Herringbone
W475-0345 W475-0370 W475-0366
W475-0346 W475-0371 W475-0367
W475-0347 W475-0372 W475-0368
W475-0344 W475-0373 W475-0369
W333-0001 W333-0006 W333-0006
W333-0002 W333-0007 W333-0007
W333-0003 W333-0008 W333-0008
LOG LOG
BRACKET BRACKET
NG NG
LP LP
5. Ensure that the tabs, located on the back wall of the fi rebox,
have been bent forward horizontally.
4
6. Install the panels in the following order:
1- right
2 - rear
RETAINER RETAINER
7. Secure the side panel using the retainers located in the top
left and right corners of the fi rebox.
8. Replace the components removed in steps 2 - 3.
9. Remove one end of the hearth assembly so that the front
brick can be inserted, then replace the end. The screen as-
sembly and glass door can now be replaced.
W415-0491 / C / 03.08.06
TAB TAB
3
1
2
3 - baffl e
4 - left