Cequent Towing Products 51096 Instructions D'installation

Vehicle Frame
Bumper
Bracket
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51096F
Wrenches: 13/16", 7/8"
Drill Bits: None
Vehicle Frame
Spacer
1
Qty. (4) Hex Bolt, 9/16"-18 x 2" Gr. 5
2
Qty. (6) Conical Washer, 5/8"
1. Raise hitch into position as shown in Figure 2.
2. Install all fasteners as shown in Figure 1. Make sure that spacers are placed between the bumper bracket and the hitch.
3. It is important to tighten the bolts to the required torque shown below.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2008 Cequent Towing Products
Installation Instructions
Bumper
Lincoln Mark LT
Bumper
Fascia
Bumper
FIGURE 1.
Tighten all 9/16"-18 GR5 fasteners with torque wrench to 120 Lb.-Ft (163 N-m).
Ford F-150
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: PU3
All fasteners typical
both sides
Bumper Bracket
3
Qty. (4) Nut, 9/16" Flanged
4
Qty. (2) Spacer, 1/4" x 1" x 2"
Sheet 1 of 3
Part Numbers:
Manufacturer's Rating or
Max Gross
Trailer WT
8,000 lb (3632 kg)
5,000 lb (2270 kg)
FIGURE 2.
51096N 5-13-08
51096
Max Tongue
WT
800 lb (363 kg)
500 lb (227 kg)
Existing
Nuts
Rev. A