Publicité
Les langues disponibles
Les langues disponibles
CAUTION
Polarity is important. If wiring is mis-connected the LED light will
not operate.
1. Connect wires to fused power source: (See Figure 3).
• Connect the (-) black wire to the negative (-) wire from the
12-volt supply.
• Connect the (+) gray or red wire along with proper fuse and
switch to the positive (+) 12-volt supply.
• Fuse must be 1-amp.
2. Note that navigation rules require sidelights to be operated
separately from anchor lights. Use either two switches or a
single switch with three positions for off/anchor/running.
Figure 3
1-Amp Fuse
(pos)
(neg)
12V DC
Green
(Starboard)
ATTWOOD LIMITED 10-YEAR WARRANTY
Because of the longevity of Attwood's LED lighting technology,
Attwood offers a limited 10-year warranty on this LED lighting
product. See Product Catalog or attwoodmarine.com for details.
© 2007 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com
Switch
(pos)
Red
(Port)
Publicité
