briebe FN-122397.2 Mode D'emploi page 14

Rotate the fasten set out of the standing shaft. Put the cover piece on the base through the standing shaft.

Rotate back the fasten set.

2. The whole assembly
Pull the height adjustment pipe out and tighten the fasten set.

Link the fan main body and the height adjustment pipe together by the fastening screw and then fix them.

3. Rear grille assembly
Unscrew the blade fastening screw and the guard fastening screw from the motor shaft.

Fix the rear guard onto the two pillars of the motor front shell.

Screw the guard fastening screw tightly in clockwise direction.

4. The assembly of fan blade
Take the black shaft protective cover out of the shaft. Insert fan blade onto shaft ensuring blade fits

properly.
Tighten blade screw onto shaft. Note: Blade screw should be tightened in anti-clockwise.

5. Front grille assembly
Open up all locking clips on the sides of the front guard.

Place the front guard into position by lining up the location plate over the top of the rear guard and push

down.
Unscrew the small nut and bolt at the bottom of the front grille, then fasten the two guards together with

them.
Secure the two guards by closing the clips over the outer rim.

OPERATION
Please press the buttons on the control panel or the buttons on the remote control to choose your desired
function. The corresponding LED lights will illuminate accordingly.
1. On/Off function
Press the button "ON/SPEED" once to turn on the unit. The unit starts to work under normal mode at low
speed.
Press the button "OFF" to turn off the unit.
2. Speed function
When the appliance is on, continue to press the "ON/SPEED" button to set your desired wind speed from
low, mid, high, indicated with the speed lights illuminating one by one.
3. Oscillation
To make the fan head oscillate, push down the oscillation knob. To stop the fan head from oscillating, pull
up the oscillation knob.
4. Mode function
Press the mode button to set your desired working mode:
Normal mode (mode indicator: red)
Nature mode (mode indicator: green)
Sleep mode (mode indicator: off).
1) Normal: under this mode, the motor works with the preset speed. You can press button "ON/SPEED"
to choose speed Low /Mid /High.
2) Natural: under this mode, you can press button "ON/SPEED" to choose speed Low /Mid /High. The
fan will operate as follows:
All manuals and user guides at all-guides.com
- 13 -