emerio WK-126134.1 Mode D'emploi page 6

WK-126134.1
HOUSEHOLD USE ONLY
PARTS DESCRIPTION
1. Lid opening button
2. Lid
3. Handle
4. Water gauge
5. Anti-calc filter
6. Heating base
7. Temperature display
8. Temperature +/-
9. ON/OFF button and indicator light
10. Dechlorination button and indicator light
11. Keep warm button and indicator light
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you clean your kettle before use by boiling
a full kettle of water twice and then discarding the water.
OPERATION OF YOUR KETTLE
Boil water to 100°C
1. Open the lid; pour out left over water from previous boiling cycle and fill with the desired amount of fresh
water to the water kettle. Always fill the kettle between the minimum (0.5L) and maximum (1.7L) marks.
Too little water will result in the kettle switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before connecting the power cord to the outlet.
This water kettle is equipped with an overfill safety feature. This will make sure that in case of overfilling
the kettle the water will not come in contact with electrical components of the kettle ensuring no unsafe
situations can occur. In case of overfill the water will be lead through the inner side of the kettle and will
exit the kettle at the bottom, away from the electrical element.
2. Connect the plug into a power outlet, the light of the ON/OFF button in the he
temperature display shows the current water temperature.
3. Press the ON/OFF button
temperature display, you will find that "100°C" flashs several times, then shows the current temperature.
4. The kettle will switch off automatically once the water has boiled. You can shut off the power by pressing
the ON/OFF button again at any moment during boiling water.
Once the water has boiled, the light of the ON/OFF button
minutes, the kettle will enter into standby mode; the temperature display will be off and the light of the
ON/OFF button will flash. Press the ON/OFF button to activate it.
NOTE: Ensure that the lid is firmly closed all the time throughout the boiling cycle. Scalding may occur if
the lid is open.
5. Once the water boils, wait 10 seconds before pouring out water to prevent hot steam from exiting through
the lid of the kettle. Lift the kettle, then pour the water. The temperature display will show "E1" when the
kettle is not on the heating base. Place it back, the display will show the current temperature again.
NOTE: operate carefully when pouring the water from your kettle as boiling water will scald.
6. Allow to cool for 30~40 seconds before reopening to boil water. Never re-boil water older than 2 hours.
7. Unplug the appliance after use.
8. Should you accidentally allow the kettle to operate without water; the boil-dry protection will
automatically switch it off. If this occurs, allow the kettle to cool before filling with cold water and
re-boiling.
All manuals and user guides at all-guides.com
once
, the kettle starts to boil water, the light of the button will flash. In the
- 5 -
ating base lights up
will stay lit
. If no further operations in 5
EN
. The