Installation; Important; Connecting To The Mains Power Supply - Abus TVAC35500 Manuel Utilisateur

Connections:
Mains connection block
Battery connection
Power connections 1 – 8
Tamper contact
Battery fuse
Power unit fuse
Mains fuse
LED control indicator:
GREEN Mains LED
RED Fault LED

6. Installation

6.1 Mounting

IMPORTANT:

Only connect the device to the mains power supply after it has been installed.
The device must be earthed at the start of installation.
This device is designed for a fixed indoor installation. Fasten the device securely and with the correct
alignment so that a minimal clearance is achieved. Allow at least 100 mm between this device and other
equipment.
Use the holes in the base for feeding the cable into the housing.
Route input and output cables via different knockouts or cable entry holes.

6.2 Connecting to the mains power supply

Connect to an external mains isolation device rated at 3A minimum, for example a fused spur, using a
cable suitable for connecting to the mains power supply (Ø 0.5 mm², 300/500 V ac).
Use suitable cable connections during the installation. Ensure that cable ties are used for all cables.
Brown cable
Green/yellow cable
Blue cable
Red cable
Black cable
Connection "+"
Connection "-"
Contact closed when cover closed (NC = normally closed)
The power supply is working correctly
Fault present:
Output fuse or battery fuse is defective
(TVAC35500 and TVAC35510 only)
20
Live
Ground
Neutral
Positive
Negative
Positive
Negative
English