Safety Instructions; Pre-Installation; Tools Required - K2 Pumps AWP00002K Notice D'utilisation

Pompe d'amorçage
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SAFETY INSTRUCTIONS

Carefully read and follow all safety instructions in this manual.
1. Do not allow pump to freeze. To do so will void warranty.
2. Pump water only with this pump.
3. Periodically inspect pump.
4. Wear safety glasses at all times when working on pumps.
5. Keep work area clean, uncluttered and properly lighted; store properly all unused tools and equipment.
6. Keep visitors and children at a safe distance from the work areas and open well heads

PRE-INSTALLATION

APPLICATION
The pitcher pump is designed to pump water from a driven well. It must be primed before lifting water.
TOOLSREQUIRED
Wrench
INSTALLATION
Thread the pump into the top of the casing of a driven well or bolt it to the cover of a dug well.
NOTE: The base of the pump comes ready for use with a1-1/4" pipe or it can be reduced with a bushing for use
with a 1" pipe. Be certain there is a drop pipe extending down into the well water from the pitcher pump. The cap is
adjustable for a wide range of handle positions.
NOTE: Sealing Pipe Joints
Use only Teflon tape or Teflon based joint compounds for making all threaded connections to the pump itself. Make sure
that all pipe joints in the suction pipe are air tight as well as water tight. If the suction pipe can suck air, the pump will not
be able to pull water from the well.
Priming the Pump
Never operate pump dry. Operating the pump without water may cause damage to the cup
leather. ALWAYS fill pump with water before starting to pump.
NOTE: The pump may need to be primed more than once before you can lift water. For best
operation a foot
valve should be installed at the bottom of the suction line.
The pitcher pump must be primed before lifting water. Pour water in the top of the pitcher pump
until it runs out of the spout. Wait 5 minutes until the cup leather swells enough to make contact
with the pump wall. If necessary add more water.
2
Pipe wrench
Figure1: Prime the Pump
For Professional Technical Support call 1-844-242-2475

Publicité

Table des Matières
loading

Table des Matières