Step By Step Installation - Orion COBALT C0500 Manuel D'utilisation

Rear Seat
figure 2
figura 2
abbildung 2

sTeP bY sTeP InsTallaTIon

step 1: Determine where the speaker will be mounted . Make sure there is a
flat area large enough for the speaker to fit properly . an uneven
mounting surface can damage the driver .
step 2: Check to make sure the space you have chosen for the speaker will
not interfere with the operation of the vehicle .
step 3: Using a template, mark the speaker hole with a pen .
step 4: Cut the hole for the speaker . When using factory locations, this step
can be passed . a hole can be cut either with a pair of metal tin snips
or a hole saw corresponding to the size of the speaker listed below .
• 4 3/4" (120mm) hole saw (5 1/4")
• 5 1/2" (140mm) hole saw (6 1/2")
step 5: Run the speaker wire to the speakers . Make sure to keep wires away
from sharp metal or other edges . When passing through metal ,use a
protective grommet .
step 6: Using the template, mark the mounting holes with a pen .
step 7: Pre-drill mounting holes using a 1 / 8 " drill bit .
step 8: Pull the wire through the speaker opening and connect to the
speaker .
step 9: Mount the speaker and grill in the hole using the same screws . Insert
the screws through the grill and the mounting holes in the basket .
WARNING: Window mechanisms and electrical wires may be hidden
from sight. CHECK FOR CLEARING BEFORE YOU DRILL!
4
All manuals and user guides at all-guides.com
© 2007 directed electronics—all rights reserved
Rear/Trunk
of Car