ELTRACE DomoClick DHB-100 Manuel D'installation page 4

DOMOCLICK
D C
OMO LICK JUNCTION SET WITH
Box and cover in polyamid, Ligature, Incorporated electrical connection including cablegland PG 16, Stirrups for wall
mounting CE
C
OMPOSITION
1 junction
1 terminal
2 heat-resistant ligatures
2 stirrups for wall mounting
self-adhesive labels "electric supply" and
"terminal"
E
ASY
Eltrace heating tapes are supplied and connected between themselves with a minimum of manipulations. Only a knife
in needed to strip the band ends. The different clicks are made up of only three parts.
S
URE
The mounting stages are visible and easily controllable. The upper and lower blades guarantee a sure contact.
F
AST
It takes only a few minutes to assemble the Click, for it involves only four stages:
1. Insert the band into the cover and the metal cone
2. Strip the band end.
3. Insert the heating tape into the Click.
4. Push the lever and shut the cover.
I
NSTALLATION PRESCRIPTIONS
The installation of bands, connections to DomoClick
the rules of the trade. Before going ahead with work on electric tracers, care will be taken to isolate them from the
mains. The DomoClick® connection and junction techniques are approved if used together with self-adjusting El-
trace heating tapes. Eltrace guarantees correct working only in relation with the mentions heating tapes. Through the
direct mounting onto the pipe, DomoClick
with the supplied ligatures. DomoClick® can also be fixed to the wall with supplied stirrups. The supply cable is to
bedirectly connected into the DomoClick
installations for gutters, DomoClick® must not be installed in a gutter or on the roof, but in a sheltered position under
the roof or eave. DomoClick
Short periods at 80°C are admitted. Important : for admitted temperatures of heating tapes, refer to the technical data
®
DomoClick
ble. Electrical supply points and terminals must be indicated with the supplied self-adhesive labels.
Q
UALIFICATIONS
Certifications CE
ELTRACE - 12, rue des frères Lumière - F-77290 - MITRY MORY - France - Tel: +33 (0)1 64 62 04 40 - Fax: +33 (0) 1 64 62 00 54 - www.eltrace.com - info@eltrace.com
In order to improve the quality of our products ELTRACE reserve the right to make changes—20140617 Domoclick Fast Connector
®
F C
AST ONNECTOR
DOMOCLICK DOMOCLICK
DOMOCLICK
1
TERMINAL
®
®
can be installed directly on pipes with a service temperature of less than 70°C.
incorporated into pipe insulation. All supply points, junctions and terminals must remain accessi-
P
RODUITS
®
® ®
- - DHB DHB-
- DHB
D C
OMOCLICK ONNECTOR
®
connectors to connection boxes will be carried out according to
®
uses less heating tape. As a general rule, DomoClick
. Any exterior supply, junction or derivation box is thus avoided. In anti-frost
- 101 101
- 101
®
is fixed to the pipe