Key Functions - Inxide XU15 Instructions

SPECIFICATIONS
Auto Scan
Time (TMR)
Speed (SPD)
Distance (DIST)
Calorie (CAL)
Odometer (ODO)
Pulse Rate (♥)

KEY FUNCTIONS

Mode
Press it to select functions. Hold it for 5 seconds to convert KM/H or Mile/H.
Set
To set value of time, distance and calories, pulse when not in scan mode.
Reset
Press to reset time, distance and calories. Hold it for 3 seconds to reset time,
distance and calories, pulse.
FUNCTION AND OPERATIONS
1. Scan
Press MODE button until "SCAN" appears, monitor will rotate through the
following functions: time, calories, speed, distance and total distance. Each
display will hold for 4 seconds.
ENGLISH
Every 4 seconds
00:00 - 99:59
0.0 - 99.9 KM/H (ML/H)
0.00 - 999.9 KM (ML)
0.00 - 9999 KCAL
0.0 - 9999 KM (ML)
40 ~ 240 BPM
2. Time (TMR)
Count the total time from exercise start to end.
3. Speed (SPD)
Display current speed.
4. Distance (DST)
Count the distance from exercise start to end.
5. Calories (CAL)
Count the total calories from exercise start to end.
6. Total Distance (ODO)
Count the total distance after installing the batteries.
7. Pulse Rate
Press MODE button until "♥"appears. Before measuring your pulse rate,
please place both your palms on the contact pads and the monitor will show
your current heart beat rate in beats per minute(BPM) on the LCD after 3~4
seconds.
Remark: During the process of pulse measurement, because of the contact
jamming, the measurement value may be higher than the virtual pulse rate
during the first 2~3 seconds, then it will return to normal level. The
measurement value can not be regarded as the basis of medical treatment.
8. Auto ON/OFF & Auto Start/Stop
Without any signal for 4 minutes, the power will turn off automatically.
When the wheel is in motion or pressing the button, the monitor is in action.
9. Alarm
The functions of time, distance and calorie can be set countdown, any of
above value goes to zero, the computer will alarm for 5 seconds. After
establishing a good target pulse, if the user's actual pulse exceed the target
pulse, the computer will alarm. Press MODE to select the function, then press
SET to adjust the value.
EXERCISE MONITOR INSTRUCTIONS
FOR XE15 XU15