Reversomatic TC100-5V Mode D'emploi

The timer switch has one push button and 3 LED's to indicate time delay for high speed operation for 20, 40 and 60 minute
(see fig 1.1).
When the timer switch is activated, the
H/ERV unit will go on high speed mode
for 20 minutes. When pushed again, it
will go for 40 minutes on high speed. On
third press, unit will speed up for 60
minutes. If the switch is showing 60
minutes and button is pressed, then the
unit will go on normal speed, with all
LED's off.
In the case of multiple switches, unit will
take command from the switch pressed
last. Each switch will indicate the
current status and
remaining time.
If all LED's are fleshing then, that is
indication of error in HERV. Please
check manual for remedies.
Installation can be done by mounting switch directly on dry wall (refer fig 2.1) or by installing it into electrical junction
box ( see fig. 2.2).
ANCHOR #6
SCREW #6
Fig 2.1 Installation on drywall
790 Rowntree Dairy Road, Woodbridge, ON Canada L4L 5V3 Tel: 905-851-6701 Fax: 905-851-8376
LED indicators
it will show
Push button
DRYWALL
3/16" HOLE
1" DIA
HOLE FOR
WIRES
Reversomatic Manufacturing Ltd.
www.reversomatic.com
Electronic Timer Switch
1 3/8"
1 5/16"
7/16"
Front view Side view
Fig 1.1 dimensional data
SCREW 6-32
Fig 2.2 Installation with electrical box
info@reversomatic.com
TC100-5V
9/16"
To main
control board
(See wiring
diagram in
our manual)
Date code label
Product label
Back view
DRYWALL
ELECTRICAL
JUNCTION
BOX
2020-10-13