VONN Lighting ORBIT Serie Guide D'installation page 3

Fig. 1
ROUND: CUT OUT
Ø4"(Ø102mm)
1. Cut (Ø4") hole in the ceiling
(Ceiling thickness 1/4" to 3/4")
Fig. 3
Green / Ground
Black / Hot
White / Neutral
Power supply
3. Connect fixture wires to building wires
Connect each supply wire with appropriate dirver wire
connector
Installer tip: The fixture features electric low voltage
(ELV or 0-10V) dimming capabilities.
Fig. 5
5. Place all wiring and connectors back in driver box. Connect
DC wire between fixture body and driver box. Put the driver
box and DC wire one into ceiling
www.vonn.com
Instructions
Dim-gray(0-10V)
Dim+purple(0-10V)
Cable to fixture
Fig. 2
2. Pull building supply wires through
ceilling cutout and open fixture box door.
Remove desired housing knockout and feed
building wires into housing using
appropriate connector.
Fig. 4
4. Remove fixture body cover by prying open with allen key
Fig. 6
6. Tighten scews and lock fixture in place
Top View
(Above Ceiling)
© VONN Lighting,2020