Télécharger
Partager
Imprimer la page
  1. Manuels
  2. Marques
  3. Uline Manuels
  4. SPA & Baignade
  5. H-1132
  6. Mode d'emploi

Uline H-1132 Mode D'emploi

Masquer les pouces
1
2
3
4
5
6

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Télécharger ce manuel
H-1132
CENTER PULL TOWEL
DISPENSER
TOOLS NEEDED
Drill
Drill Bit
Dispenser x 1
NOTE: For both permanent and temporary
mounting, ensure that proper mounting
hardware is used for appropriate wall
composition. Enclosed hardware may not
be compatible with your wall surface.
PERMANENT MOUNTING
1. Place opened dispenser in intended mounting
position and mark location of three screw holes.
Recommended mounting height is 56" from floor
to bottom of dispenser. (See Figure 1)
Figure 1
2. Install top two screws halfway into wall.
Position dispenser on screws.
PAGE 1 OF 6
1-800-295-5510
uline.com
Phillips Screwdriver
Level
Mounting Bracket x 1
MOUNTING INSTRUCTIONS
56"
Tape Measure
PARTS
Screw x 3
3. Install bottom screw through hole in dispenser
and tighten.
4. Finish tightening top two screws.
TEMPORARY OR PORTABLE MOUNTING
1. Place mounting bracket in position and mark location
of two screw holes. Recommended mounting height is
65.5" from floor to top of bracket. (See Figure 2)
Figure 2
Mounting Bracket
2. Screw bracket to wall and mount dispenser.
NOTE: Temporary mounting may be made
permanent by installing third (bottom) screw
through hole in dispenser back.
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Wall Anchor x 3
65.5"
Key x 1
0123 IH-1132

Publicité

loading

Manuels Connexes pour Uline H-1132

Sommaire des Matières pour Uline H-1132

  • Page 1 Para Español, vea páginas 3-4. Pour le français, consulter les pages 5-6. H-1132 1-800-295-5510 uline.com CENTER PULL TOWEL DISPENSER TOOLS NEEDED Drill Drill Bit Phillips Screwdriver Level Tape Measure PARTS Dispenser x 1 Mounting Bracket x 1 Screw x 3...

  • Page 2: Loading Instructions

    (See Figure 6) NOTE: To clean Figure 6 dispenser, use a soft wipe with ITEM # BRAND SETTING mild soap S-7724 Uline and water. S-15752 Uline S-7725 Scott S-11827 Scott S-12851 Kleenex 4. Remove perforated cardboard core from center of towel roll, if applicable.

  • Page 3: Herramientas Necesarias

    H-1132 800-295-5510 uline.mx DESPACHADOR DE EXTRACCIÓN CENTRAL HERRAMIENTAS NECESARIAS Taladro Broca Desarmador Nivel Cinta de Cruz de Medir PARTES 1 Despachador 1 Soporte para Instalación 3 Tornillos 3 Taquetes 1 Llave INSTRUCCIONES DE INSTALACIÓN NOTA: Tanto para instalación permanente 3. Inserte el tornillo inferior a través del orificio del como temporal, asegúrese de usar la tornillería...

  • Page 4: Instrucciones De Carga

    (Vea Diagrama 6) NOTA: Para Diagrama 6 limpiar use un paño suave con MODELO NO. MARCA CONFIGURACIÓN jabón suave y S-7724 Uline agua. S-13796 Uline S-7725 Scott S-11827 Scott S-12851 Kleenex 4. Retire el núcleo de cartón perforado del centro del rollo de toallas, si es necesario.

  • Page 5: Distributeur De Serviettesà Tirage Central

    H-1132 1-800-295-5510 uline.ca DISTRIBUTEUR DE SERVIETTES À TIRAGE CENTRAL OUTILS REQUIS Perceuse Mèche Tournevis Niveau à Ruban à de perceuse cruciforme bulles mesurer PIÈCES Distributeur x 1 Support de fixation x 1 Vis x 3 Ancrage mural x 3 Clé x 1 INSTRUCTIONS D'INSTALLATION 4.

  • Page 6: Instructions De Chargement

    8. Amorcez la distribution. N° 1 N° 2 Figure 6 Arrachez les premières feuilles froissées. Nº D'ARTICLE MARQUE RÉGLAGE (Voir Figure 6) S-7724 Uline Nº 3 REMARQUE : S-13796 Uline Nº 3 Pour nettoyer, S-7725 Scott Nº 1 utilisez un chiffon doux...