Bercomac 700556 Feuille D'instructions

If the tractor has a manual clutch you must install this update kit in order to install the drive mechanism.
Replace the original right and left supports with
these new supports.
Install the new left & right supports (items 1 & 2) on
each side of the vehicle.
Item # Description
1 & 2 Left & right supports
3 Hex bolt
5/16'' n.c. x 1''
4 Hex bolt
5/16'' n.c. x 1/2''
(qty 3)
5 Hex nut 5/16''
(qty 4)
Replace the original short pin with this new longer pin
and sleeve.
Install the drive mechanism (item 1).
# Item Description
1 Back of drive
mechanism
2 Front of drive
mechanism
4 Pin
(qty 2)
5 Hair pin
(qty 2)
6 Carriage bolt
5/16'' x 1''
7 Bracket
8 Knob
FI_700556-EN
UPDATE KIT #700556 (for 700527)
INSTALLATION
Install the parts according to the following instructions:
Action
Install as shown.
Insert in supports as
shown.
Insert in supports as
shown.
Install on bolts and
tighten firmly.
Action
Hook on the tractor frame,
right side.
Install between the supports.
Insert as shown.
On the right side, new pin
and sleeve (item 3) from the
outside.
On the left side, pin from the
inside.
Secure the pins.
Insert in the back of the drive
as shown.
Install on the bolt as shown
and on the tractor frame.
Tighten to lock the drive
frame in place.
Instruction Sheet
WARNING
TO PREVENT INJURIES:
It is the person who installs the drive mechanism
responsibility to make sure that when the clutch
is disengaged that all moving parts stop.
For more information, do not hesitate to contact
the technical support.
Install new supports
Install new pin and sleeve
K-10