GEV 000841 Mode D'emploi page 4

Solar-powered LED Duo fl oodlights
with motion detector LPL
Operation
The solar-powered LED fl oodlights with motion
detector operate with passive infrared technology.
If the motion detector's PIR sensor detects
a moving heat source in its detection range, it
automatically switches on. Static heat sources
do not switch the motion detector on. The
twilight switch can be set to ensure that the
motion detector will operate either during the
day and night or only when dark. The in-built
timer switches the solar-powered LED
fl oodlights off 10 seconds after the last
movement is detected. The solar panel recharges
the in-built rechargeable battery during the day.
Safety instructions
Under no circumstances does the
warranty cover damage resulting
from failure to observe these
instructions. We do not accept liability for any
indirect damage. Similarly, we can accept no
liability for any material damage or bodily injury
caused by mishandling or failure to observe the
safety instructions. In these cases, no warranty
claim may be made. In addition, for safety and
compliance reasons, you are not authorised to
dismantle or alter the solar-powered LED Duo
fl oodlights in any way. If in any doubt, rather than
mounting, connecting and installing
equipment yourself, contact a qualifi ed
technician.
Mounting position for the solar module
Before installing the solar module, choose a
suitable outdoor position. During the day,
check that there is enough light to recharge the
Special notice for solar-powered fl oodlights
Condition
Shaded positions reduce battery charging
There is less sunlight during the winter months
than in the summer
Dirt, foliage or snow on the solar panels will
reduce the charging rate
Cold temperatures reduce battery performance
batteries. The solar module should not be placed
behind glass as this fi lters out any infrared light
required to charge the infrared light. Respect
the length of the LED Duo fl oodlight connection
cable. It is not possible to extend the cable.
Mounting position for the solar-
powered LED Duo fl oodlights with
motion detector
Motion detection is maximised by moving at
an angle to the motion detector. Therefore, the
motion detector should be installed in a position
that ensures that objects/people do not move
directly towards the device.
Installation
Install the solar module as shown in fi g. A.
Tilt the solar module in an optimal position for
capturing sunlight (fi g. B).
Install the LED Duo fl oodlights with motion
detector as shown in (fi g. C).
Connect the battery pack plug to the LED Duo
fl oodlight socket (fi g. D) and place the LED
Duo fl oodlights on the wall connection plate
(fi g. E). Plug the solar panel plug into the LED Duo
fl oodlight socket (fi g. E1) and switch on (fi g. E2).
Tilt both fl oodlights to the required position
(fi g. F).
the
Settings
Twilight switch approx. 3 to 1000 lux. (fi g. G -H)
The angle of detection can be limited using an
attachable screen, which can be cut to size
(fi g. I).
Result
Reduced LED light duration
Reduced LED light duration
Reduced LED light duration
Reduced LED light duration
4
Battery and rechargeable battery
information
Only operate the solar-powered LED Duo
fl oodlights with 3.6 V NiMh 750 mAh.
Old batteries may not be disposed of with
the unsorted household waste. Owners
of used batteries are required by law to
recycle the batteries and can return them free
of charge to the place of sale. Batteries contain
material which is harmful to the environment
and health and must therefore be disposed of
professionally.
Technical information
Field of detection 130°
Range approx. 10 m, depending on installation height
Time setting approx. 10 seconds after the last movement is detected
Twilight switch approx. 3 - 1,000 lux, infi nitely variable
Operating voltage 3.6 V
Rechargeable batteries 3.6 V NiMh 750 mAh (included)
Light power 2 x 1 W LED, maintenance-free
Solar module polycrystalline solar panel
Protection type IP44
Protection class III
Light duration approx. 50 days if switched on daily
(with fully charged batteries)
Recommended installation height approx. 1.8 m
LED fl oodlights dimensions W 112 x H 144 x D 70 mm
Solar module dimensions W 88 x H 155 x D 63 mm
Technical and design features may be subject to change.
Gutkes GmbH
Owiedenfeldstr. 2 a Postfach 730 308 Fax: +49(0) 511 / 958 58 05
30559 Hannover 30552 Hannover www.gev.de
Germany Germany service@gev.de
Recycling instructions
This device may not be disposed of with
the unsorted household waste. Owners of
old devices are required by law to dispose
of this device professionally. Contact your
town council for further information.
5